Everything below concerns mass confirmation. We keep the language plain, cite what the science says, and separate well-supported claims from open questions.
Last reviewed on 2026-02-10. Where a claim depends on a specific study, the study is described rather than over-claimed.
TB-500 is a synthetic seven-residue peptide whose sequence, LKKTETQ, matches the N-terminal actin-binding region of thymosin beta-4. It is usually supplied in an N-terminally acetylated form, a modification that blocks the free amino terminus and can influence behavior in solution. In the research literature the same sequence appears under several names, including thymosin beta-4 fragment and shortened thymosin beta-4. Because it is a short peptide rather than the full 43-residue parent protein, its measured properties differ from those reported for thymosin beta-4 as a whole, and the two are not interchangeable in experimental design.
Thymosin beta-4 itself is a small, widely expressed protein that sequesters monomeric actin and participates in cell migration, angiogenesis, and tissue repair. Researchers have examined the shortened fragment as a possible mimic of some of these activities, reasoning that the actin-binding motif lies within the first few residues. Binding to monomeric actin has been observed in cell-free systems. Whether the fragment reproduces the broader effects of the full protein in living tissue remains an open question, and findings from animal models are frequently cited without a clear bridge to human physiology.
Discussion of TB-500 appears in several distinct literatures that rarely cite one another. Peer-reviewed studies usually describe in vitro assays or small animal experiments and are cautious about extrapolation. Veterinary and sports communities circulate anecdotal reports with limited methodological detail. Commercial listings add a third layer, often using the name interchangeably with thymosin beta-4 even though the two molecules differ in size and sequence. Regulatory status varies by country, and the compound is not a licensed medicine in most jurisdictions, so readers comparing sources should check which molecule and which purity each source actually describes.
Peptide bonds are susceptible to hydrolysis under extreme pH and to enzymatic cleavage if proteases are present. Heat, oxidising agents, and prolonged exposure to light also contribute to loss of material. Aggregation can occur at high concentrations or in certain buffer systems, and it may not be visible to the eye. Storage at -20 C or below is typical for both powder and aliquoted solutions, and desiccation of the powder is preferred.
Identity and purity are usually assessed by reversed-phase high-performance liquid chromatography together with mass spectrometry. The chromatogram provides a purity estimate as a percentage of total peak area, while the mass spectrum confirms that the observed mass matches the expected value. Amino acid analysis or tandem mass spectrometry sequencing can provide additional confirmation. Reported purity figures depend on the column, gradient, and detection wavelength, so values from different laboratories are not directly comparable without method details.
| Property | Value | Notes |
|---|---|---|
| Molecular class | Synthetic peptide | N-terminal fragment of thymosin beta-4 |
| Residue count | Seven | Sequence LKKTETQ |
| Approximate mass | 889 Da | Acetylated seven-residue peptide |
| Common synonyms | TB4 fragment, TB500 | Not identical to full-length TB4 |
| Reported activity | Actin binding | Observed mainly in cell-free systems |
TB-500 is a short synthetic peptide sold under a trade name rather than a systematic chemical name. Suppliers usually describe it as a fragment of thymosin beta-4 and ship it as a lyophilised powder intended for laboratory use. Because the label is commercial, the exact sequence attributed to it is not fully consistent across catalogues, and some listings present a seven-residue peptide while others describe related fragments of similar length. It is not an approved medicine in any major jurisdiction, and it is handled as a research chemical.
Thymosin beta-4 itself is a natural peptide of 43 residues found in many cell types and body fluids. Its best-characterised function is binding and sequestering actin monomers, which influences cytoskeletal dynamics. The sequence most often associated with TB-500, LKKTETQ, corresponds to part of that actin-binding region. A different fragment, Ac-SDKP, is also derived from the same parent peptide and is studied in its own right, which is one reason discussions of thymosin fragments can become confusing. The two are structurally distinct and are not interchangeable.
Interest in the fragment grew during the 1990s and 2000s, when it moved from laboratory work into sports and supplement markets. Anti-doping bodies added thymosin beta-4 fragments to prohibited lists, and a small number of adverse analytical findings have been reported in competition testing. Published controlled human trials remain scarce. Most mechanistic evidence comes from cell culture and animal models, and those studies examine endpoints such as cell migration, wound closure and inflammation markers. That evidence supports research interest but does not establish clinical benefit, and broad regenerative claims should be read as unverified.
TB-500 is a shorthand label used in supplier catalogs and online discussion for a short synthetic peptide described as a fragment of thymosin beta-4. Most product listings present it as the N-terminally acetylated heptapeptide Ac-LKKTETQ, a sequence corresponding to the actin-binding region of the parent protein. The name is not a formal chemical designation and does not appear in standard nomenclature systems. Because labeling practices vary between vendors, two products sold under the same name may not contain the same molecule, and the stated sequence should be treated as a claim rather than a fixed definition.
Thymosin beta-4 is a naturally occurring protein of 43 amino acids found in most mammalian cells, where it binds actin monomers and influences filament dynamics. It was first isolated from thymus tissue in the early 1980s, and its actin-binding activity was later mapped to a short region near the N-terminus. The synthetic fragment sold as TB-500 was designed to reproduce that region rather than the full protein. Whether a short fragment reproduces the behavior of the intact molecule remains an open question, since the parent protein carries additional structural elements outside the binding region.
Published research on the intact protein is substantial, covering actin regulation, cell migration, and wound models. Research using the heptapeptide fragment specifically is far smaller, and much of the circulating material originates in supplier documentation rather than peer-reviewed reports. Where fragment studies do exist, they often employ different sequences, chain lengths, or terminal modifications, which complicates direct comparison across papers. Readers encountering claims about TB-500 should therefore separate evidence about thymosin beta-4 from evidence about the fragment itself.
Research peptides are typically supplied as a white to off-white lyophilised powder in a sealed vial. The dry solid is more stable than a solution and is normally kept refrigerated or frozen until use. Dissolution is usually done in water, phosphate-buffered saline or a similar aqueous medium, depending on the assay. Because the material is hygroscopic and easily contaminated, opening vials in a low-humidity environment and recording the lot number before use are standard laboratory practices.
Once in solution, short peptides are generally less stable than the dry powder, and repeated freeze-thaw cycles are a common cause of loss. Laboratory guidance usually calls for aliquoting on first dissolution and storing aliquots at -20 °C or below, away from light. Adsorption to plastic and glass surfaces can lower measured concentration, particularly at low concentrations, so container material and buffer choice can affect results. Visible cloudiness, colour change or unexpected precipitate is a signal to re-check the material.
== External links == Bispecific monoclonal antibody entry in the public domain NCI Dictionary of Cancer Terms Bispecific+antibodies at the U.S. National Library of Medicine Medical Subject Headings (MeSH)
=== pH-metric === The pH-metric set of techniques determine lipophilicity pH profiles directly from a single acid-base titration in a two-phase water–organic-solvent system. Hence, a single experiment can be used to measure the logarithms of the partition coefficient (log P) giving the distribution of molecules that are primarily neutral in charge, as well as the distribution coefficient (log D) of all forms of the molecule over a pH range, e.g., between 2 and 12. The method does, however, require the separate determination of the pKa value(s) of the substance.
The GTP-binding domain is conserved in both EF-1alpha/EF-Tu and also in EF-2/EF-G and thus seems typical for GTP-dependent proteins which bind non-initiator tRNAs to the ribosome. The GTP-binding translation factor family also includes the eukaryotic peptide chain release factor GTP-binding subunits and prokaryotic peptide chain release factor 3 (RF-3); the prokaryotic GTP-binding protein lepA and its homologue in yeast (GUF1) and Caenorhabditis elegans (ZK1236.1); yeast HBS1; rat Eef1a1 (formerly "statin S1"); and the prokaryotic selenocysteine-specific elongation factor selB.
==== Size-exclusion chromatography (FPLC) ==== Due to the apparent size differences by the degree of PEGylation of the protein, size-exclusion chromatography (fast protein liquid chromatography or FPLC) can be used. There is a negative correlation between molecular weight and the retention time of the PEGylated protein in the chromatogram; larger protein, or more PEGylated protein elutes first, and smaller protein, or intact protein the latest.
Sources: en.wikipedia.org
==== Capillary electrophoresis ==== Capillary electrophoresis (CE)is emerging as the preferred analytical method for YTX analysis, as it has significant advantages over the other analytical techniques used, including high efficiency, a fast and simple separation procedure, a small sample volume required, and minimal reagent is required. The techniques used for YTX analysis include: CE with ultraviolet (UV) detection and CE coupled to mass spectrometry (MS). CEUV is a good method for YTX analysis, as its selectivity can easily differentiate between YTXs and DSP toxins. The sensitivity of these techniques can, however, be poor due to the low molar absorptivity of the analytes. The technique gives a limit of detection (LOD) of 0.3 μg/ml and a limit of quantification (LOQ)of 0.9 μg/ml. The sensitivity of conventional CEUV can be improved by using micellar electrokinetic chromatography (MEKC). CEMS has the added advantage over CEUV of being able to give molecular weight and/or structural information about the analyte. This enables the user to carry out unequivocal confirmations of the analytes present in the sample. The LOD and the LOQ have been calculated as 0.02 μg/ml and 0.08 μg/ml, respectively, again meeting the European Commission directive.
=== Nigeria === To combat money laundering, the Economic and Financial Crimes Commission was established in 2003. This body works alongside the Central Bank of Nigeria and the National Drug Law Enforcement Agency, to investigate and prosecute, individuals charged with the crime. The Money laundering Act was also established in 2011. This act contains elaborate provisions on the legal and institutional framework to prevent money laundering. The act also established the Special Control Unit against Money Laundering, under the EFCC. This act made key changes to the repealed act, some of which are;
=== United States === In consultation with Dr. Carlton Turner, President Ronald Reagan issued Executive Order 12564. In doing so, he instituted mandatory drug-testing for all safety-sensitive executive-level and civil-service Federal employees. This was challenged in the courts by the National Treasury Employees Union. In 1988, this challenge was considered by the US Supreme Court. A similar challenge resulted in the Court extending the drug-free workplace concept to the private sector. These decisions were then incorporated into the White House Drug Control Strategy directive issued by President George H.W. Bush in 1989. All defendants serving on federal probation or federal supervised release are required to submit to at least three drug tests. Failing a drug test can be construed as possession of a controlled substance, resulting in mandatory revocation and imprisonment. There have been inconsistent evaluation results as to whether continued pretrial drug testing has beneficial effects. Testing positive can lead to bail not being granted, or if bail has already been granted, to bail revocation or other sanctions. Arizona also adopted a law in 1987 authorizing mandatory drug testing of felony arrestees for the purpose of informing the pretrial release decision, and the District of Columbia has had a similar law since the 1970s. It has been argued that one of the problems with such testing is that there is often not enough time between the arrest and the bail decision to confirm positive results using GC/MS technology.
Sources: en.wikipedia.org
No. Thymosin beta-4 is a 43-residue protein, while TB-500 refers to a seven-residue fragment corresponding to its N-terminal region. The two names are often used loosely in commercial and community writing, which obscures the difference in size, sequence, and likely behavior.
The fragment contains an actin-binding motif, and cell-free experiments show that it can interact with monomeric actin. That observation is the basis for interest in cell migration and repair processes. Effects reported in animals are not established for humans.
Purity is usually stated by the supplier rather than fixed by a pharmacopoeial monograph, and typical listings report a percentage from reverse-phase HPLC. Independent verification is uncommon. Because no single accepted specification exists, comparisons between lots and between suppliers are difficult.
The lyophilised powder is typically held at -20 C or lower in a dry, dark place. Reconstituted solutions are aliquoted and frozen to avoid repeated freeze-thaw cycles.